3.2.17
Paper Pressure Guide.
1. Remove the platen assembly (3.2.16)
2. Remove the two paper chute springs (1) located on each side of the paper pressure
guide (2).
3. Remove the screw (3), located on the left side frame of the printer mechanism,
directly under the upper tractor shaft.
4. Remove the release lever detent spring (4) located on the right side frame of the
printer mechanism.
5. Separate the claws and remove the release lever (5).
6. Remove the paper pressure bar (6) by sliding it to the right.
7. Using needle-nose pliers, squeeze the nylon latch (7) to release the paper out sensor
wire harness (8).
8. Detach the cable from CN1 of the sensor board (9).
9. Lift the paper pressure guide and remove it.
P/N 50907502
Spring: (Paper Chute)
P/N 50910201
Spring: Detent (Release Lever)
P/N 53478706
Lever: Release
P/N 53478801
Block: Release Lever Guide
P/N 56625001
Cable: Cut Sheet Sensor Assembly
Maintenance
RSPL
RSPL
RSPL
RSPL
RSPL
3 - 38
Pacemark 3410 Service Handbook
B.2.06
B.2.06
B.2.06
B.2.06
B.2.06