OKIDATA Pacemark 3410 Service Handbook page 177

Factory default settings are printed in Bold Italic.
Except as indicated, the menu for the Epson/IBM model is the same as the menu for the
ML/Pacemark model.
Group
Set-Up Operator Panel Function
(continued)
Print Suppress Effective
Auto CR (IBM only)
(10 cpi - IBM ONLY)
(12 cpi - IBM ONLY)
Pacemark 3410 Service Handbook
Item
Reset Inhibit
Auto LF
CSF Bin Select
SI Select Pitch
SI Select Pitch
Time Out Print
(Epson/IBM)
Auto Select
Sensor Disable
3 - 91
Setting
Full Operation
Changing this setting to Limited
Limited Operation
Operation deactivates the menu
mode and these control panel
buttons: TOP OF FORM,
MICRO FEED UP/DOWN,
PRINT QUALITY, and PITCH.
This is used in situations where
several people are using the
printer.
To restore to full operation,
power OFF the printer. Press
and hold PRINT QUALITY and
PITCH while powering ON the
printer.
The printer will be in Menu Mode.
Change this setting to FULL
OPERATION.
No , Yes Changing this to Yes prevents a
reset signal from the computer
from resetting the printer to its
defaults.
Yes , No
Determines whether the DC3
code causes the printer to ignore
data until a DC1 code is received.
No , Yes
No , Yes
Bin 1 , Bin 2 Only available when the dual bin
cut sheet feeder (CSF 3002) is
installed.
Determines which bin is active.
17.1 , 15 cpi Sets the pitch of condensed
mode from 10 cpi using the SI
code.
20 , 12 cpi Sets the pitch of condensed
mode from 12 cpi using the SI
code.
Valid , Invalid When set to Valid, contents of
the buffer will print when
additional data is not received for
a predetermined amount of time.
No , Yes
No , Yes
Notes
Maintenance