Top Of Form; General Information; Setting Top Of Form; Reset Top Of Form And Menu To Factory Defaults - OKIDATA Pacemark 3410 Service Handbook

3.3.05

Top Of Form

General Information

The Top of Form is the place on the page where printing starts.
When the printer advances to the next page, it stops at the top of form.
The Pacemark 3410 can store a different top of form position for the three standard paper feed
paths (top, rear, and bottom).

Setting Top of Form

The same procedure is used for all three paper paths.
1. Load paper into the printer by pressing FORM FEED.
2. Set the Top of Form position.
The red line on the plastic ribbon shield marks the base of the printing line. Use this as
your guide when setting the Top of Form.
To increase the space between the top edge of the paper and the print start position
(advance the paper), press and hold TOP OF FORM while pressing MICRO FEED up.
To decrease the space between the top edge of the paper and the print start position
(retract the paper), press and hold TOP OF FORM while pressing MICRO FEED down.
3. Release TOP OF FORM. The position you set in Step 2 is registered in the printer's
memory.

Reset Top of Form and Menu to Factory Defaults

To reset the Top of Form and the Menu to Factory Defaults, follow this procedure.
1. Before resetting the Menu, Okidata STRONGLY RECOMMENDS printing the
Menu.
Printing the Menu provides a reference of customized settings.
When the Menu is reset, all customized setting are LOST.
2. Power OFF the printer.
3. Press and hold SELECT and TOP OF FORM while powering ON the printer.
Pacemark 3410 Service Handbook 3 - 93 Maintenance