Printhead Gap/Release Lever Microswitches - OKIDATA Pacemark 3410 Service Handbook

3.2.30

Printhead Gap/Release Lever Microswitches

1. Remove the printer mechanism (3.2.07).
2. Remove the mounting screw to remove the release lever microswitch (1).
3. Push down on the mounting tab and detach the upper printhead gap microswitch (2).
4. Push down on the mounting tab and detach the lower printhead gap microswitch (3).
5. Using a needle nose pliers, detach the nylon cable clamp (4) and remove the harness
and switches from the printer mechanism.
NOTES:
The harness connector must be detached from the main logic board.
Refer to the Microswitch 2 Modification procedure in Section 3.3 - Adjustments.
P/N 56209901 Switch: Micro (Adj & Rel Lever)
P/N 56624801 Cable: Micro Switch Assembly (Adj & Rel Lever)
P/N 56614301 Cable: Micro Switch (Cover Open)
Maintenance 3 - 64 Pacemark 3410 Service Handbook
RSPL B.2.07
RSPL B.2.07
RSPL B.2.04