3.3.7 Carriage Cable, Homing sensor
(1)
Remove the ribbon protector.(See 3.3.1)
(2)
Remove the head.(See 3.3.2)
(3)
Remove the upper cover.(See 3.3.4)
(4)
Remove the printer unit.(See 3.3.6)
(5)
Open the three claws at the bottom and remove the head cable clamp.
(6)
Remove Flat cable 1 from the head cable clamp 2.
(7)
Remove the homing sensor 3 (photo interrupter) from the head cable clamp 2.
(8)
Assemble in the reverse order of disassembly.
Notes :
(1) Take care not to fold the head cable 1 during installation. Curve slightly the head
cable 1 when assembling into the fasteners.
(2) Make sure that there is not any dust or oil on the connector contact sections A to
D. If it is found, wipe it off by alcohol.
43471801TH Rev.1
3
2
Oki Data CONFIDENTIAL
1
38 /