OKIDATA Pacemark 3410 Service Handbook page 36

9. In order to perform a Serial Interface Diagnostic Test, you should
1. place a DB-25P Loopback Test Connector on the serial port.
2. press and hold PARK during power ON.
3. press and hold LINE FEED during power ON.
4. change the menu setting for SERIAL I/F DIAGNOSTIC TEST to YES.
A. 1
B. 1 and 2
C. 1 and 3
D. 1 and 4
Correct Answer: D
page 4-42, Service Handbook., Rev 01
Page 4-44, Service Handbook, Rev 02
10. According to Appendix A in the Service Handbook, the main logic board contains which
of the following?
A. One 3.5 Amp fuse (F1)
B. Test Points for (+38vdc, +5vdc, +8vdc, -8vdc)
C. Jumper plug S2
D. All of the above
Correct Answer: D
Page A-2, Service Handbook, Rev 01
Page A-4, Service Handbook, Rev 02
Course Administration i - 20 Pacemark 3410 Service Handbook