Paper Bail Assembly - OKIDATA Pacemark 3410 Service Handbook

3.2.28

Paper Bail Assembly

1. Remove the printer mechanism (3.2.07).
2. Remove the bail motor / ribbon gear assembly (3.2.27).
3. Detach the paper bail springs (1).
NOTE:
The right and left bail arm springs are different; be careful to install them properly.
4. Remove the idler gear (2).
5. Detach the "E" snap ring and remove the bail open cam (3).
6. Detach the "E" snap ring (4) and remove the left bail arm (5) from the paper bail bar
(6) by pulling toward the left.
7. Remove the right bail arm (7) by pulling toward the right while expanding the
clamps (8).
8. Detach the right bail arm from the paper bail bar.
P/N 50054401 Assembly: Indicator Shaft
P/N 50910701 Spring: Bail Arm (Left)
P/N 50910801 Spring: Bail Arm (Right)
P/N 51210201 Gear: Idle (Bail Arm)
P/N 51214701 Cam: Bail Open
P/N 53478501 Bail Arm (Left)
P/N 53478502 Bail Arm (Right)
Maintenance
RSPL
RSPL
RSPL
RSPL
RSPL
RSPL
RSPL
3 - 60 Pacemark 3410 Service Handbook
B.2.07
B.2.07
B.2.07
B.2.07
B.2.07
B.2.07
B.2.07