Release Lever / Gear Assemblies - OKIDATA Pacemark 3410 Service Handbook

3.2.31

Release Lever / Gear Assemblies

6. Remove the printer mechanism (3.2.07).
NOTE:
Before performing the next step, place the release lever toward the front of the printer.
This will remove tension from the detent spring.
7. Detach the E-Ring, washer and spring, then remove the idle gear (1).
8. Remove the (Release Lever) detent spring (2).
9. Pry open the center claws and slide the release lever (3) from the printer mechanism.
10. Pry open the center claws then remove drive gear A (large gear) (4).
11. Pry open the center claws then remove drive gear B (small gear) (5).
P/N 50910305 Spring: Idle Gear
P/N 51214201 Gear: Drive A
P/N 51214301 Gear: Drive B
P/N 51214401 Gear: Idle (Release Lever)
P/N 53478706 Lever: Release
P/N 50910201 Spring: Detent (Release Lever)
Maintenance
RSPL
RSPL
RSPL
RSPL
RSPL
RSPL
3 - 66 Pacemark 3410 Service Handbook
B.2.07
B.2.07
B.2.07
B.2.07
B.2.06
B.2.06