Release Lever / Gear Assemblies - OKIDATA Pacemark 3410 Service Manual
Hide thumbs
Also See for Pacemark 3410:
- Service handbook (308 pages) ,
- User manual (273 pages) ,
- Instruction manual (9 pages)
Table of Contents
Advertisement
Page: 65
Service Guide PM3410
Chapter 3 Maintenance & Disassembly
3.2.31 Release Lever / Gear Assemblies
(3.2.07).
6. Remove the printer mechanism
NOTE:
Before performing the next step, place the release lever toward the front of the printer. This will remove
tension from the detent spring.
7. Detach the E-Ring, washer and spring, then remove the idle gear (1).
8. Remove the (Release Lever) detent spring (2).
9. Pry open the center claws and slide the release lever (3) from the printer mechanism.
10. Pry open the center claws then remove drive gear A (large gear) (4).
11. Pry open the center claws then remove drive gear B (small gear) (5).
P/N 50910305 Spring: Idle Gear RSPL B.2.07
P/N 51214201 Gear: Drive A RSPL B.2.07
P/N 51214301 Gear: Drive B RSPL B.2.07
P/N 51214401 Gear: Idle (Release Lever) RSPL B.2.07
P/N 53478706 Lever: Release RSPL B.2.06
P/N 50910201 Spring: Detent (Release Lever) RSPL B.2.06
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Advertisement
Table of Contents
Troubleshooting
