Printhead Gap/Release Lever Microswitches - OKIDATA Pacemark 3410 Service Manual

Page: 64
Service Guide PM3410
Chapter 3 Maintenance & Disassembly

3.2.30 Printhead Gap/Release Lever Microswitches

(3.2.07).
1. Remove the printer mechanism
2. Remove the mounting screw to remove the release lever microswitch (1).
3. Push down on the mounting tab and detach the upper printhead gap microswitch (2).
4. Push down on the mounting tab and detach the lower printhead gap microswitch (3).
5. Using a needle nose pliers, detach the nylon cable clamp (4) and remove the harness and switches
from the printer mechanism.
NOTES:
The harness connector must be detached from the main logic board.
Refer to the Microswitch 2 Modification procedure in Section 3.3 - Adjustments.
P/N 56209901 Switch: Micro (Adj & Rel Lever) RSPL B.2.07
P/N 56624801 Cable: Micro Switch Assembly (Adj & Rel Lever) RSPL B.2.07
P/N 56614301 Cable: Micro Switch (Cover Open) RSPL B.2.04
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)