Adjustments; Printhead Gap Adjustment - OKIDATA ML320 Service Manual

3.3

ADJUSTMENTS

General Information
This section contains the procedure for performing the adjustment on the Microline 320
and 321 printers. This procedure may be required when replacing either consumables or
parts. The disassembly / assembly procedures list the required adjustment and refer you
to this section. Failure to perform these procedures may result in unnecessary service calls.

3.3.01 Printhead Gap Adjustment .

Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Service Guide ML320/ML321
Chapter 3 Maintenance & Disassembly
Page: 78