Paper Bail Assembly - OKIDATA Pacemark 3410 Service Manual

Page: 62
Service Guide PM3410
Chapter 3 Maintenance & Disassembly

3.2.28 Paper Bail Assembly

(3.2.07).
1. Remove the printer mechanism
2. Remove the bail motor / ribbon gear assembly (3.2.27).
3. Detach the paper bail springs (1).
NOTE:
The right and left bail arm springs are different; be careful to install them properly. 4. Remove the idler
gear (2).
5. Detach the E snap ring and remove the bail open cam (3).
6. Detach the E snap ring (4) and remove the left bail arm (5) from the paper bail bar (6) by pulling toward
the left.
7. Remove the right bail arm (7) by pulling toward the right while expanding the clamps (8).
8. Detach the right bail arm from the paper bail bar.
P/N 50054401 Assembly: Indicator Shaft RSPL B.2.07
P/N 50910701 Spring: Bail Arm (Left) RSPL B.2.07
P/N 50910801 Spring: Bail Arm (Right) RSPL B.2.07
P/N 51210201 Gear: Idle (Bail Arm) RSPL B.2.07
P/N 51214701 Cam: Bail Open RSPL B.2.07
P/N 53478501 Bail Arm (Left) RSPL B.2.07
P/N 53478502 Bail Arm (Right) RSPL B.2.07