Shpf Elevator Bin Movement Service Check - Lexmark MS911 Service Manual

Action
Step 6
a
Reseat the cable J11 on the SHPF controller board.
b
If applicable, reseat the junction connectors on the cable.
c
Make sure that the cable does not block the path of moving parts.
d
Check the cable for damage, and replace if necessary.
Does the problem remain?
Step 7
a
Reseat the interface cable on the SHPF controller board and printer
controller board.
b
Reseat the junction connector on the cable.
c
Check the cable for damage, and replace if necessary.
Does the problem remain?
Step 8
a
Reseat all the cables on the SHPF controller board.
b
Reset the printer.
Does the problem remain?
Step 9
Replace the controller board. See
page 364.
Does the problem remain?

SHPF elevator bin movement service check

Action
Step 1
a
Remove the paper from the bin.
b
Make sure that the bin is properly installed.
c
Reseat the interface cable that is plugged into the printer.
d
Reset the printer.
Does the problem remain?
Step 2
a
Make sure that the elevator bin stack limit actuator and switch are
properly installed.
b
Check the actuator and switch for damage, and replace if necessary.
See "SHPF elevator bin stack limit actuator removal" on page 429
and "SHPF elevator bin stack limit switch removal" on page
Does the problem remain?
"SHPF controller board removal" on
Diagnostic information
173
Yes
Go to step 7.
Go to step 8.
Go to step 9.
Contact the next level
of support.
Yes
Go to step 2.
Go to step 3.
432.
4021, 7421
No
The problem is solved.
The problem is solved.
The problem is solved.
The problem is solved.
No
The problem is solved.
The problem is solved.