Staple Finisher Stapling Failure Service Check - Lexmark MS911 Service Manual

Action
Step 15
a
Reseat the interface cable on the staple finisher controller board and
printer.
b
Reseat the junction connector on the cable.
c
Check the cable for damage, and replace if necessary.
Does the problem remain?
Step 16
a
Reseat all the cables on the staple finisher controller board.
b
Reset the printer.
Does the problem remain?
Step 17
Replace the controller board. See
removal" on page 244.
Does the problem remain?

Staple finisher stapling failure service check

Action
Step 1
a
Remove any debris from the paper path.
b
Reseat the interface cable that is plugged into the printer.
c
Reset the printer.
Does the problem remain?
Step 2
a
Test the motor (staple finisher aligner).
Enter the Diagnostics menu, and then navigate to:
MOTOR TESTS > Staple Finisher Motor Tests > TE align
b
Check if the carriage is moving properly.
Is it moving properly?
Step 3
a
Reseat the cable on the motor.
b
Make sure that the motor is properly installed.
c
Check the motor and cable for damage, and replace if necessary. See
"Motor (staple finisher aligner) removal" on page
Does the problem remain?
"Staple finisher controller board
254.
Diagnostic information
161
Yes No
Go to step 16. The problem is solved.
Go to step 17. The problem is solved.
Contact the next level The problem is solved.
of support.
Yes No
Go to step 2. The problem is solved.
Go to step 4. The problem is solved.
4021, 7421