Tips On Using Labels; Tips On Using Letterhead - Lexmark MS911 Service Manual

–
Have windows, holes, perforations, cutouts, or embossing.
–
Have metal clasps, string ties, or folding bars.
–
Have an interlocking design.
– Have postage stamps attached.
–
Have any exposed adhesive when the flap is in the sealed or closed position.
–
Have bent corners.
– Have rough, cockle, or laid finishes.
•
Adjust the width guides to fit the width of the envelopes.
•
Before loading the envelopes on the tray, flex the stack of envelopes back and forth to loosen them, and
then fan them. Straighten the edges on a level surface.
Note: A combination of high humidity (over 60%) and high printing temperature may wrinkle or seal envelopes.

Tips on using labels

•
From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the labels
loaded in the tray.
• Print samples on labels being considered for use before buying large quantities.
•
For more information on label printing, characteristics, and design, see the Card Stock & Label Guide on the Lexmark
Web site at http://support.lexmark.com.
•
Use labels designed specifically for laser printers.
• Do not use labels with slick backing material.
•
Do not use labels with exposed adhesive.
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets
also contaminate the printer and the cartridge with adhesive, and could void the printer and toner cartridge
warranties.
• Before loading labels on the tray, flex and fan labels to loosen them. Straighten the edges on a level surface.

Tips on using letterhead

•
Use letterhead specifically for laser printers.
• Print samples before buying large quantities.
•
Before loading letterhead, flex and fan the sheets.
•
When printing on letterhead, take note of the page orientation.
Source
Trays
Printing Side with the
letterhead
One‑sided Faceup
Two‑sided Facedown
General information
30
4021, 7421
Paper orientation
Load the sheet with the
top edge toward the back
of the tray.
Load the sheet with the
top edge toward the front
of the tray.