Booklet Maker Symptoms - Lexmark MS911 Service Manual

Action
Step 20
a
Make sure that the elevator belt springs, elevator bin front and rear
brackets, and elevator belt holders are properly installed.
b
Check the parts for wear or damage, and replace if necessary.
Does the problem remain?
Step 21
a
Reseat the interface cable on the SHPF controller board and printer.
b
Reseat the junction connector on the cable.
c
Check the cable for damage, and replace if necessary.
Does the problem remain?
Step 22
a
Reseat all the cables on the SHPF controller board.
b
Reset the printer.
Does the problem remain?
Step 23
Replace the controller board. See
page 364.
Does the problem remain?

Booklet maker symptoms

Booklet maker symptoms
Symptom
A persistent Open door H and remove paper
from beneath area H10 message appears.
A persistent Remove paper from bin 3
message appears.
The bifold edge is not centered.
"SHPF controller board removal" on
Action
See "Booklet maker tamper paper jam service
check" on page
See "HPBF bin service check" on page
See "Bifold edge alignment service check" on
page 179.
Diagnostic information
177
Yes
Go to step 21.
Go to step 22.
Go to step 23.
Contact the next level
of support.
96.
178.
4021, 7421
No
The problem is solved.
The problem is solved.
The problem is solved.
The problem is solved.