Parallel Port [X] Disabled [56]; Photoconductor Low [84.Xy]; Photoconductor Very Low [84.Xy]; Printer Had To Restart. Last Job May Be Incomplete - Lexmark MS911 Service Manual

Hide thumbs Also See for MS911:

Table of Contents

Parallel port [x] disabled [56]

Try one or more of the following:

From the printer control panel, touch Continue to clear the message.

Enable the parallel port. From the printer control panel, navigate to:

Network/Ports > Parallel [x] > Parallel Buffer > Auto

Note: The printer discards any data received through the parallel port.

You may need to order a replacement photoconductor. If necessary, select Continue on the control panel to clear the

message and continue printing.

You may need to replace the photoconductor unit very soon.

If necessary, touch Continue on the control panel to clear the message and continue printing.

From the printer control panel, touch Continue to clear the message and continue printing.

For more information, visit

Try one or more of the following:

Check if the toner cartridge is missing. If missing, install the toner cartridge.

For information on installing the cartridge, see the "Replacing supplies" section of the User's Guide.

If the toner cartridge is installed, then remove the unresponsive toner cartridge, and then reinstall it.

Note: If the message appears after reinstalling the supply, then the cartridge is defective. Replace the toner

Try one or more of the following:

If the photoconductor unit is missing, then install it.

If the photoconductor unit is installed, then remove and then reinstall it.

Note: If the message appears after reinstalling the supply, then replace the defective photoconductor unit.

Remove and replace the defective printer hard disk.

http://support.lexmark.com

Diagnostic information

or contact customer support.

Xm91x5 Mx91x