Shpf Pre-Eject Failure Service Check - Lexmark MS911 Service Manual

Action
Step 10
a
Reseat the interface cable on the SHPF controller board and printer
controller board.
b
Reseat the junction connector on the cable.
c
Check the cable for damage, and replace if necessary.
Does the problem remain?
Step 11
a
Reseat all the cables on the SHPF controller board.
b
Reset the printer.
Does the problem remain?
Step 12
Replace the controller board. See
page 364.
Does the problem remain?

SHPF pre-eject failure service check

Action
Step 1
a
Reseat the interface cable that is plugged into the printer.
b
Reset the printer.
Does the problem remain?
Step 2
Enter the Diagnostics menu, and then navigate to:
Printer setup > Reset engine service error
Note: Perform this step every time a service error occurs.
Does the problem remain?
Step 3
a
Remove the upper left cover.
b
Bypass the front door switch.
c
Test the motor (SHPF compiler pre-eject).
Enter the Diagnostics menu, and then navigate to:
MOTOR TESTS > Staple and Hole Punch Finisher Motor Tests >
Compiler pre‑eject
d
Check if the middle aligner is properly moving.
Is it properly moving?
"SHPF controller board removal" on
Diagnostic information
123
Yes No
Go to step 11. The problem is solved.
Go to step 12. The problem is solved.
Contact the next level The problem is solved.
of support.
Yes No
Go to step 2. The problem is solved.
Go to step 3. The problem is solved.
Go to step 5. Go to step 4.
4021, 7421