Mailbox Incorrect Bin Exit Service Check - Lexmark MX81 series Service Manual

Mailbox incorrect bin exit service check

Action
Step 1
Check the auto connector end of the printer below the mailbox.
Is it free of damage?
Step 2
Open the rear door and actuate the sensor (rear door interlock) to
override the interlock mechanism.
Perform feed test on all bins. Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Do a feed test for each bin and check each diverter.
Note: Diverter 1 to 3 are normally closed while Diverter 4 is normally
open if no output option is above the mailbox. A diverter will open
when media is about to enter its assigned bin (Example: When feeding
to Bin 2, Diverter 2 will open to direct the media path toward Bin 2).
Do they operate properly during the feed test on each bin?
Step 3
Check each diverter if:
•
there is any visible damage or deformity
•
they could move freely
Are the diverters ok?
Step 4
Check the solenoids. If damaged, then replace the solenoid. Go to
"Mailbox solenoid removal" on page
Reseat the solenoid connectors on the controller PCBA, then POR the
machine.
Does the error remain?
Step 5
Reseat all the connectors on the controller PCBA, then POR the machine.
Does the error remain?
606.
Diagnostic information
217
Yes No
Go to step 2. Replace the upper
interface cable of the
printer under the
mailbox.
Go to step 6. Go to step 3.
Go to step 4. Replace the mailbox
assembly. Go to
"Mailbox assembly
removal" on page
601.
Go to step 5. The problem is solved.
Replace the controller The problem is solved.
PCBA. Go to "Mailbox
controller PCBA
removal" on page
609.
If the error persists,
then replace the
mailbox. Go to
"Mailbox assembly
removal" on page
601.
7463