Motor (Trifold Guide) Failure Service Check - Lexmark MS911 Service Manual

Action
Step 13
a
Reseat all the cables on the booklet maker controller board.
b
Reset the printer.
Does the problem remain?
Step 14
Replace the controller board. See
removal" on page 462.
Does the problem remain?

Motor (trifold guide) failure service check

Action
Step 1
a
Reseat the interface cable that is plugged into the SHPF.
b
Reset the printer.
Does the problem remain?
Step 2
Enter the Diagnostics menu, and then navigate to:
Printer setup > Reset engine service error
Note: Perform this step every time a service error occurs.
Does the problem remain?
Step 3
a
Remove the front cover.
b
Test the motor (trifold guide).
Enter the Diagnostics menu, and then navigate to:
MOTOR TESTS > Booklet Maker Motor Tests > Trifold guide
c
Check if the belts, gears, and rollers are properly moving.
Are they properly moving?
Step 4
a
Reseat the cable on the motor.
b
Make sure that the motor is properly installed.
c
Check the motor and cable for damage, and replace if necessary. See
"Motor (trifold guide) removal" on page
Does the problem remain?
"Booklet maker controller board
489.
Diagnostic information
149
Yes No
Go to step 14. The problem is solved.
Contact the next level The problem is solved.
of support.
Yes No
Go to step 2. The problem is solved.
Go to step 3. The problem is solved.
Go to step 5. Go to step 4.
Go to step 5. The problem is solved.
4021, 7421