Shpf Ejector Failure Service Check - Lexmark MS911 Service Manual

Action
Step 10
a
Reseat the cable J12 and J13 on the SHPF controller board.
b
If applicable, reseat the junction connectors on the cables.
c
Make sure that the cables do not block the path of moving parts.
d
Check the cables for damage, and replace if necessary.
Does the problem remain?
Step 11
a
Reseat the interface cable on the SHPF controller board and printer.
b
Reseat the junction connector on the cable.
c
Check the cable for damage, and replace if necessary.
Does the problem remain?
Step 12
a
Reseat all the cables on the SHPF controller board.
b
Reset the printer.
Does the problem remain?
Step 13
Replace the controller board. See
page 364.
Does the problem remain?

SHPF ejector failure service check

Action
Step 1
a
Reseat the interface cable that is plugged into the printer.
b
Reset the printer.
Does the problem remain?
Step 2
Enter the Diagnostics menu, and then navigate to:
Printer setup > Reset engine service error
Note: Perform this step every time a service error occurs.
Does the problem remain?
"SHPF controller board removal" on
Diagnostic information
125
Yes No
Go to step 11. The problem is solved.
Go to step 12. The problem is solved.
Go to step 13. The problem is solved.
Contact the next level The problem is solved.
of support.
Yes No
Go to step 2. The problem is solved.
Go to step 3. The problem is solved.
4021, 7421