System Settings - Muratec Office Bridge IF-200 Operating Instructions Manual

IF-200 from Muratec

6.2. System Settings

To change any of these settings, press SETUP from the Main screen. Scroll to System
Settings and press EDIT. Use the scroll keys to move to the field you want to change
and press EDIT. Make the change and press OK. Press ESC until you return to the
Main screen.
Table 3. System Settings and Options
SETTING
DATE
TIME
Time Zone
Time Display
Phone Dialing Prefix
Netmask IP Address
Gateway IP Address
IF-200 Address
E-Mail Header
Print Errors
Dial Method
Need Dial Tone
Insert Comma After 9
Poll Mode
24
OPTIONS AND DESCRIPTION (Default settings are in
BOLD type)
Current date.
Current time.
Time zone for your geographic region.
AM-PM, 24-HR. Whether you want time displayed in
military (24-HR) or 12 hour (AM-PM) time.
Digit(s) to be dialed prior to any phone number stored in the
IF-200 (i.e. 9).
Network mask.
IP address of router.
Static, Use DHCP, Use RARP, AUTO ASSIGN IP. You may
specify a static IP address, use DHCP to obtain an IP address,
use RARP to obtain an IP address, or auto assign an IP
address. When the IF-200 auto assigns an IP address, it first
uses DHCP and then RARP (if DHCP fails) to obtain an IP
address.
Normal, Don't Print, Verbose. Dictates whether the e-mail
header (text) is printed to the fax machine or stripped.
Yes, No. If enabled, prints errors on the fax machine as they
occur.
Tone, Pulse-10, Pulse-20. The method of dialing supported by
the telephone lines in your geographic region.
Yes, No. Whether or not the IF-200 data modem used to
connect to the Internet waits for dial tone before dialing the
phone number. In some countries the dial tone is weak and
should not be waited for.
Yes, No. Whether or not a comma should be inserted after 9
when it is the first digit of a phone number dialed on the fax
machine.
Periodic, Scheduled, Disabled. Determines whether the IF-
200 checks for mail according to the Poll Interval, the Poll
Schedule or not at all.