Programming And Retrieving One-Touch/Speed-Dialing Setting; Retrieving One-Touch/Speed-Dialing Settings; Programming One-Touch/Speed-Dialing Settings - Muratec F-320 User Manual

Programming and Retrieving One-touch/Speed-dialing setting

Retrieving One-touch/Speed-dialing settings

When you want to retrieve One-touch/Speed-dialing settings by mail, enter the following title on the Subject line.
%get-onetouch#xxxx%
%get-speed-dial#xxxx%
To edit the retrieved parameter, store the E-mail file as text (.txt) on your PC.
Note: When the mail is sent properly, you will receive mail that describes all One-touch/Speed-dialing settings.

Programming One-touch/Speed-dialing settings

To change or update the retrieved parameter, open the text file (.txt). Copy the body text and paste it on the body
of the newly created E-mail message. Delete any headers that may be present in the body of the E-mail.
When you want to program One-touch/Speed-dialing settings by mail, enter the following title on the Subject
line.
%set-onetouch#xxxx%
%set-speed-dial#xxxx%
Follow the following rules to program the settings:
1. All records should be enclosed with @start-record and @end-record.
2. You can not begin a new line in between @start-record and @end-record.
3. Do not enter other records on the lines containing @start-record and @end-record.
Each record should be entered as follows:
No.;Name;FaxNumber;MailAddress;FaxGroup;MailGroup;FileFormat;
Parameter
1 No. One-touch numbers or Speed-dialing numbers
2 MailAddress Mail address (maximum of 50 characters)
3 FaxNumber Fax number (maximum of 40 characters)
4 FaxGroup Group numbers for fax No.1~32 used
For multiple entries, separate with commas.
Only effective when fax number is designated.
5 MailGroup Group numbers for mail No.33~65 used
For multiple entries, separate with commas.
Only effective when mail address is designated
6 FileFormat File format upon mail transmission
tiff-s/tiff/pdf
Only effective when mail address is designated
4. Each parameter in a record should be separated with a semicolon (;).
5. You can not enter more than one record per line.
6. Each record should start at the beginning of a new line.
Note: According to the e-mail software or mail server, the long parameter may be divided into two or more lines
automatically. In this case, after entering about 70 characters, press Enter key to start a new line and put
one space at the beginning of the next line.
2.18
(xxxx is the password for remote access.)
(xxxx is the password for remote access.)
(xxxx is the password for remote access.)
(xxxx is the password for remote access.)
Value