Set Ip Address Of Gpsone Session +Wpdip; Set Port Of Gpsone Session +Wpdpt - Multitech CDMA Wireless Modem Reference Manual

Set IP Address of gpsOne Session +WPDIP

Description: This command allows the user to set the IP address of the gpsOne session if the TCP/IP
transport layer is used.
Values: <ip_address>
Specified in format xxx.xxx.xxx.xxx where xxx is 000 to 255.
Syntax: Command syntax: AT+WPDIP=<ip_address>
Command
AT+WPDIP?
Note: Query current gpsOne IP.
AT+WPDIP=192.168.135.124

Set Port of gpsOne Session +WPDPT

Description: This command allows the user to set the port value for the gpsOne session if the TCP/IP
transport layer is used.
Values: <port>
Value is carrier specific.
Syntax: Command syntax: AT+WPDIP=<port>
Command
AT+WPDPT?
Note: Query current
gpsOne port value.
AT+WPDPT=4911
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C
Chapter 13 – Position Determination (GPS) AT Commands
Possible Responses
+WPDPT: 4911
OK
OK
Note: New gpsOne port value set.
Possible Responses
+WPDIP:192.168.135.124
OK
OK
Note: New gpsOne IP set.
93