Table of Contents
Advertisement
Calling Line Identification Restriction +CLIR
Description:
This command allows control of the outgoing caller ID restriction supplementary service.
Values:
<mode>: sets the caller ID restriction for outgoing calls
0: Outgoing Caller ID works normally, according to the subscription of the Caller ID
service.
1: Outgoing Caller ID is restricted. The called party will see 'Restricted' on their Caller ID
display.
Note that this command works by automatically pre-pending a *67 to the outgoing dialing
string. Thus, this command will only work on CDMA networks that recognize a *67 to
suppress outgoing caller ID. Also, the original dialing string cannot be longer than 29
characters in length.
Syntax:
Command syntax: AT+CLIR=<mode>
Command
AT+CLIR=1
Note: Restrict outgoing caller ID.
AT+CLIR?
Note: Ask for current functionality
Calling Line Identification Presentation +CLIP
Description:
This command allows control of the incoming caller ID presentation supplementary service.
When presentation of the CLI (Calling Line Identification) is enabled (and the carrier allows),
+CLIP response is returned after the RING unsolicited result code. By default, +CLIP is
enabled.
Values:
<mode>: parameter enable or disables the caller ID unsolicited command
0: Disable
1: Enable
Syntax:
Command syntax: AT+CLIP=<mode>
Command
AT+CLIP=1
Note: Enable CLIP
AT+CLIP?
Note: Ask for current functionality
AT+CLIP=0
Note: Disable CLIP presentation
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C
Chapter 9 – Supplementary Service Commands
Possible Responses
OK
Note: Command valid
+CLIR :<mode>
OK
Note: <mode> as defined below
Possible Responses
OK
Note: CLIP is enabled
+CLIP:<mode>
OK
Note: <mode> defined as below
RING
Note: Incoming call
+CLIP: "8585551212",129
Note: Incoming call with number presentation
OK
Note: Command valid
69
Advertisement
Table of Contents
