Table of Contents
Advertisement
Select Pulse Dialing P
Description:
This command is used to select pulse dialing. Not relevant to CDMA data services; "P" is not
sent in dial string.
Syntax:
Command syntax: ATP
Command
ATP
Note: select pulse dialing.
Basic S-Registers S<X>
Description:
The S-registers store configuration parameters that are used for dialing or during an
established call. The value of an S-register may be set by using the syntax: ATSn=<value>
where n is the register number and <value> is a decimal value.
Values:
<n> ATS command index. Ranges from 0-11.
<value> Value for the ATS command.
Syntax:
Command syntax: ATS<n>=<value>
Command
ATS<n>=<value>
Note: set S-registers value
ATS0?
Note: Disable or enable automatic answering (value: 0-255)
0: Disable;
1-255: Enable after [(value-1)x6 sec.]
ATS3?
Note: Carriage return character
ATS4?
Note: Line feed character
ATS5?
Note: Backspace character
ATS6?
Note: Pause before blind dialing (value: 2-10)
ATS7?
Note: Number of seconds to establish end-to-end data connection
(value: 1-255)
ATS8?
Note: Number of seconds to pause when "," is encountered in dial
string (value: 0-255)
ATS9?
Note: Carrier detect threshold in increments of 0.1 seconds
(value: 0-255)
ATS10?
Note: Number of tenths of a second from carrier loss to
disconnect (value: 1-254)
Value 255: disable carrier detect
ATS11?
Note: DTMF tone duration and spacing in milliseconds (value: 50-
255)
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C
Chapter 17 – Extended AT Commands in IS707.3
Possible Responses
OK
Note: Command is valid
Possible Responses
OK
002
OK
Note: always 3 characters padded with
zeros
013
OK
010
OK
008
OK
002
OK
050
OK
002
OK
006
OK
014
OK
095
OK
132
Advertisement
Table of Contents
