Chapter 10 - Data Commands; Using At Commands During A Data Connection; Select Mode +Fclass - Multitech CDMA Wireless Modem Reference Manual

C 10 - D
HAPTER

Using AT Commands During a Data Connection

To use AT Commands during a data connection (e.g. while the product is in online mode), it is necessary
either to switch to offline mode, or to use the +WMUX command to enable Commands / Data multiplexing.
Note: currently the +WMUX command is not supported yet.
Switch From Online to Offline Mode
To switch from online mode to offline mode, the "+++" sequence must be sent. Following this, the product
gets back to offline mode with an "OK" response, and an AT command can be sent.
Note: the "+++" sequence only works with the +ICF command using the following settings:
•
8 data bits, with no parity
•
7 data bits, with even parity
Switch From Offline to Online Mode
See the ATO command description.

Select Mode +FCLASS

Description: This command puts the product into a particular operating mode for fax.
Values: <n>
0: Data
1: Fax class 1
2.0: Fax class 2.0
Syntax: Command syntax: AT+FCLASS= <n>
Command
AT+FCLASS=?
Note: Test command
AT+FCLASS=0
Note: Data mode requested
AT+FCLASS=2.0
Note: Fax class 2 mode requested
AT+FCLASS?
Note: Current value
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C
C
ATA OMMANDS
Possible Responses
+FCLASS: 0, 2.0
OK
Note: If fax class 1 not supported
OK
Note: Command valid
OK
Note: Command valid
+FCLASS: 2.0
OK
Note: Command valid
Chapter 10 – Data Commands
72