Request Identification Information I; Restore Factory Setting &F; Save Configuration &W - Multitech CDMA Wireless Modem Reference Manual

Request Identification Information I

Description: This command causes the product to transmit one or more lines of information from the
DCE.
Syntax: Command syntax: ATI<num>
Command
ATI0
Note: Display manufacturer data
ATI3
Note: Display software revision data
ATI6
Note: Display capability data
Restore Factory Setting &F
Description: This command is used to restore the factory setting from NV memory. The settings that are
affected by this command are shown in Chapter 20. This command will reset the modem as
the very last part of its operation.
Syntax: Command syntax: AT&F
Command
AT&F
Save Configuration &W
Description: This command writes the current configuration to NV. See table in Chapter 20 for a list of
items.
Syntax: Command syntax: AT&W
Command
AT&W
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C
Possible Responses
MODEM
800 1900
OK
S/W VER: WISMOQ ...
OK
+CGSM, +CIS707, ...
OK
Possible Responses
OK
Note: Command valid, modem resets
Possible Responses
OK
Note: Command valid
Chapter 11 – V24-V25 Commands
81