Access Overload Class +WAOC
Description:
This command is used to set the Access Overload Class.
Values:
<number>
Access overload value range – 0 to 15.
Syntax:
Command syntax: AT+WAOC=<number>
Command
AT+WAOC?
Note: Get current Access Overload Class
AT+WAOC=7
Note: Set Access Overload Class to 7
Slot Cycle Index +WSCI
Description:
This command is used to set the slot cycle index.
Values:
<number>
Slot cycle index, ranges from 0 to 7.
Syntax:
Command syntax: AT+WSCI=<number>
Command
AT+WSCI?
Note: Read the current slot cycle index
AT+WSCI=1
Note: Set the slot cycle index
Primary Browser Gateway +WBGP
Description:
This command is used to set the primary browser gateway IP address (Ipv4). If a browser is
not natively supported by the modem, this command will return ERROR.
Values:
<num>
0-255
Syntax:
Command syntax: AT+WBGP=<num>,<num>,<num>,<num>
Command
AT+WBGP?
Note: Get current gateway
AT+WBGP=255,255,255,0
Note: Set primary gateway to 255.255.255.0
Secondary Browser Gateway +WBGS
Description:
This command is used to set the secondary browser gateway IP address (Ipv4). If a browser
is not natively supported by the modem, this command will return ERROR.
Values:
<num>
0-255
Syntax:
Command syntax: AT+WBGS=< num >,< num >,< num >,< num >
Command
AT+WBGS?
Note: Get current primary gateway
AT+WBGS=255,21,255,0
Note: Set secondary gateway to 255.21.255.0
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C
Chapter 16 – Provisioning AT Commands
Possible Responses
+WAOC: 5
OK
OK
Possible Responses
+WSCI: 2
OK
OK
Possible Responses
+WBGP: 127,0,0,1
OK
OK
Possible Responses
+WBGS: 127,0,0,1
OK
OK
126