Table of Contents
Advertisement
Message Overwriting +WMGO
Description:
The +CMGW command writes an SMS to the first location available. To write an SMS to a
specified location, the +WMGO command forces the product to write an SMS (with the
+CMGW command) to the location specified with +WMGO, but for just one +CMGW
command.
Values:
<loc>: Location number of the record to write or overwrite
Syntax:
Command syntax: AT+WMGO= <loc>
Command
AT+WMGO=0
AT+WMGO=30
On the next AT+CMGW command, the record number used will be the one specified by the
AT+WMGO command. The location is forgotten and, in order to perform a second overwrite,
+WMGO has to be used again.
If the external application specifies a free location, and if an incoming message is received
before the AT+CMGW command, the product may store the incoming message at a location
available. This could be the one specified by +WMGO (the product does not prevent from
this). If the user then issues an AT+CMGW command without changing the AT+WMGO
location, the new message will be overwritten!
Note: that this location number is not kept over a software reset.
Change SMS Status +WUSS
Description:
The +WUSS command enables or disables a change of the SMS message status following
a +CMGR or +CMGL command.
Values:
<mode>:
0: The SMS Status will change.
1: The SMS Status will not change.
Syntax:
Command syntax: AT+WUSS = <mode>
Command
AT+WUSS=1
AT+WUSS=0
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C
Possible Responses
OK
Note: Next MSG write will be to index 0
+CMS ERROR: 302
Note: Invalid index (out of range)
Possible Responses
OK
OK
Note: If lower layer failure, +CMS ERROR: 513
Chapter 8 – Short Messages Commands
66
Advertisement
Table of Contents
