Rear/ Side of the main power switch
Water
Heating Device
Keeps the ink at a
proper temperature.
Clamp Lever (Rear)
Interlocked with the Clamp
Lever (side).
Roll holder
Set on both sides of the core of the
roll media to hold the media.
Supports the cores of 2 inch and 3
inch.
Configuration and Function
Pre-Heater
Preheats the media before printing.
(Located inside the platen)
Voltage selector switch
Switches 100 to 120V and 200 to 240V
depending on the supply voltage using this
machine. To avoid damage of this machine by
incorrect setting, do not touch this switch
except in the installation.
USB Connector
USB2.0-compliant interface connector.
Main Power Switch 2
Turns on/off with the main power
switch 1.
AC Inlet (Inlet 2)
Connects the UV LED unit.
Main Power Switch 1
Turns on/off the power of this machine
(except UV LED).
AC Inlet (Inlet 1)
Connects the power cable.
1
1-5