Heater; Media Sensor - MIMAKI UJV-160 Operation Manual

Heater

Pre-heater and Print heater are equipped on the platen.
The Pre-heater is used for pre-heating of the media prior to printing to prevent rapid temperature changing.
The Print-heater improves the image quality in printing.
• While heating, the platen is very hot. Not to get burned, when replacing media, lower the
heater temperatures and wait until the platen temperature drops.
• When replacing the media with a thin one, lower the heater temperatures and wait until the
platen temperature drops adequately. Setting a thin sheet of media while the platen is hot
may cause the media to stick to the platen or cause wrinkling or curling of the media.

Media Sensor

The media sensor detects the presence of the media and the media length.
This machine has a media sensor on the platen (in the rear).
• Set the media so that the media sensor located in the rear of the platen is covered with the
media without fail. The media can not be detected unless it is placed over the sensor.
Configuration and Function

Media Sensor

1
1-9