MIMAKI UJV-160 Operation Manual page 78

Setting list
The settings of the print condition are as follows. The underlined has been set as default.
These settings can be registered on the "Type".
Item
MEDIA COMP( P.3-9)
MediaFeed SETUP
( P.3-12)
HEATER SET
( P.3-11) TEMP
PRINT
MODE
( P.3-13)
UV LEVEL( P.3-15)
UV SCAN ADD
INK LAYERS
MARGIN
REFRESH
VACUUM( P.3-16)
PRIORITY( P.3-17)
MEDIA DETECT
SETUP RESET( P.3-19)
3-8
Setting
-9999 to 0 to 9999
FEED NORMAL/
METHOD DIRECT
OFF/ 20 ~ 50°C
Pre-Heater
(OFF/ 68 ~ 122°F)
OFF/ 20 ~ 50°C
Print Heater
(OFF/ 68 ~ 122°F)
STANDARD/
QUALITY
FINE/FAST
SCAN
Bi-D/Uni-D
DIRECTION
LOGICAL
PICTURE/OFF
SEEK
W h i t e L a y e r -
ON/OFF
Print
HIGH/STANDARD/
LOW/NONE/
NO PRINT
0 to 9
1 to 9
LEFT -10 to 0 to 85
RIGHT -10 to 0 to 85
LEVEL 0, 1, 2, 3
OFF/WEAK/
S T A N D A R D /
STRONG
HOST/PLOT
DETECT
SELECT/WIDTH
METHOD
MEDIA AUTO/
WIDTH 210 to 1620mm
-
Setting the print condition
Outline
Prints the pattern to adjust the media
feed.
Sets about media feed.
Sets heater conditions.
Sets the drawing quality and the draw-
ing direction.
Sets the UV light intensity.
Adds the number of UV scanning that
cures ink by irradiating UV to the end of
the image after drawing.
Prints with layers.
Sets the margin on the both sides of the
media.
Refreshes the ink head during drawing
or in a standby.
Sets the adsorbing level for the media.
(Supported from the firmware ver.1.80)
Sets the priority between PRINT MODE
and INK LAYERS.
Sets the way of media detection.
Sets the media width. (
(Supported from the firmware ver.2.00)
Resets the settings.
P.3-18)