MIMAKI UJV-160 Operation Manual page 102

When the 600 cc cartridge is used
● Setting the 600 cc cartridge
• The 600 cc cartridge can be used only by setting the cartridge to the printer.
• The 440 cc and 600 cc cartridges can be used together on one printer.
1
Prepare the 600 cc cartridge.
• Attach the 600 cc ink pack and the IC chip (supplied with the 600 cc ink pack) to the eco
case.
2
Set the 600 cc cartridge.
● If the following messages are displayed
Display
N E A R E ND : MMCC Y Y K K
I n k P a c k C h k : MMCC Y Y K K
I N K E N D : MMCC Y Y K K
4-6
The ink in the ink cartridge is low.
• For the 600 cc cartridge, you can perform cleaning even if NEAR END, but the
ink may end during drawing. Early replacement is recommended.
Pull out the cartridge and visually check the remaining amount of ink.
• When ink ended:
Replace the 600 cc ink pack and the IC chip in the eco case with the new one.
• When ink remains:
Set the 600 cc cartridge again. ("NEAR END" is displayed again.)
The ink in the ink cartridge ended.
• Replace the 600 cc ink pack and the IC chip in the eco case with the new one.
Outline