Setting The Adsorbing Level - MIMAKI UJV-160 Operation Manual

Setting the adsorbing level

Set when you want to change the adsorbing level. (Supported from the firmware ver.1.80)
1
When <LOCAL> is displayed, press the
FUNCTION
2
Press the
3
Select the type 1 to 4 with the
key, and press the
4
Select the [VACUUM] with the
key, and press the
5
Select the adsorbing level with the
key, and press the
6
Press the
Item
STRONG
STANDARD
WEAK
OFF
3-16
key.
key.
ENTER
ENTER
ENTER
ENTER
key to finish.
END
Adsorbing level is strong.
Adsorbing level is standard.
Adsorbing level is low.
The media does not adsorbing.
key.
key.
key.
Outline
< L OC A L . 1 >
F U NC T I ON
S E T U P < E N T >
S E T U P
S E L E C T : T Y P E 1
[ 1 ]
V A CUUM < e n t >
[ 1 ] V A CU UM
S E T U P : S T A ND A RD