MIMAKI UJV-160 Operation Manual page 44

8
Pull out the roll media evenly, then turn
the clamp lever to the back.
• Pulling some positions of the media lightly,
confirm that the the roll media is evenly pulled out,
then turn the clamp lever to the back.
9
Unlock the roll stopper.
• Push the roll stopper arm to the end to release the
roll stopper pin and to unlock the roll stopper.
10
Hold the media with the media retainer
gently.
• Set the media not to get out of the right end pinch
roller.
• When using a thick media, remove the media
retainer from the media before drawing.
• Set media on the left by 55mm or more from the side plate on the right.
• If a media is on the right more than fixed position, a warning
is displayed. Set the media again.
2-14
Media
Media retainer
Roll stopper arm
Pinch roller
Media retainer
MED I A POS I T I ON
Side plate (right)