Preparing Heaters; Changing Temperature Settings Of The Heater - MIMAKI UJV-160 Operation Manual

Preparing Heaters

Set the heater temperature according to the media used.

Changing temperature settings of the heater

The temperature of the heater can be changed by [HEATER] of the setup mode.
( P.3-11 "Changing the heater temperature setting")
• When purchased, the heater temperature is set "OFF".
• Since the temperature can be adjusted in drawing, you can set the proper temperature.
• Depending on the environmental temperature, it may take several minutes to several ten minutes to
reach the set temperature.
1
When <LOCAL> is displayed, press the
HEATER
2
Press the
3
Set the each temperature of the heater
with the
press the
• Select the heater with the
• Set the temperature with the
4
Heating of the heater starts.
• The [HEAT] lamp lights in orange.
5
Heating ends.
• When the heater reaches the set temperature, the [HEAT] lamp goes out, then the
[CONSTANT] lamp lights in green.
6
Press the
2-32
key.
key.
HEATER
keys, and
key.
ENTER
key to finish.
ENTER
< L OCA L . 1 >
The set temperature ： 20 to 50°C
( OF F
Temperature set in [HEATER]
keys.
of each type in the [SET UP].
keys.
PRE PR T
3 5 ° C 4 0 ° C
Heater temperature
confirming display
4 0 ° C 4 0 ° C
OF F )