Precautions For Use - MIMAKI UJV-160 Operation Manual

Precautions for use

Protection against dust
• Use this machine in a room that is not dusty.
• When leaving the work place after the
working hours, be sure to remove the media
from the roll hanger to avoid dust.
• Store media not to put dust on it. Wiping
dust off the media, dust will be put on the
media due to static electricity.
• Due to the dust on the head, ink drops will
fall down on the media during printing. If so,
be sure to clean up the head.
( P.2-36)
Ink cartridges
• If the ink cartridge is moved from a cold
place to a warm place, leave it in a place of
use for three hours or more and use it.
• Open the ink cartridge just before installing.
Leaving it open for a long time will cause
abnormal printing.
• Be sure to store ink cartridges in a cold and
dark place.
• Once the ink opened, be sure to use ink up
early. The ink passed for a long time after
opening the cartridge will lower the printing
quality.
• Using other than exclusive ink will break this
machine. In this case, repairing of this
machine is your responsibility.
• Never refill the ink cartridge with ink.
• Do not pound the ink cartridge nor shake it
violently. If so, ink may leak out of the
cartridge.
xii
CAUTION
Periodic exchange parts
• There are some parts which must be
periodically
distributors or dealers for maintenance.
Adjusting the level
• Keep this machine horizontal.
Handling of cleaning solution
• Be sure to store the cleaning solution in a
cold and dark place. Store the maintenance
liquid in a place that is out of the reach of
children.
Handling of the antifreeze liquid
• Be sure to store the antifreeze liquid in a
cold and dark place.
• Store the antifreeze liquid in a place that is
out of the reach of children.
Heater
• Do not spill liquid on the platen as this may
cause failure of the heater or firing.
• Do not touch the platen with bare hand while
the heater is hot; otherwise, you can get
burned.
• When moving the machine, wait until the
heater temperature drops adequately.
As a criterion, wait at least 30 minutes after
you turn off the power.
Moving the machine must be limited to on
the same floor where there is no steps.
When moving the machine to any place
other than on the same step-free floor,
contact your distributor.
replaced. Contract with