Confirming The Heater Temperature - MIMAKI UJV-160 Operation Manual

• The heater temperature can be preset according to the media used.
P.3-6 "Setting the print condition in a set"
• The temperature set by the operations above does not reflect the heater settings of the type
registration. The set continues until the power is turned off or the temperature is newly set with
the following conditions.
(1) Change the type of the setup mode.
(2) Change the heater temperature of the setup mode.
(3) Set the heater temperature from the computer.
• If the RIP in use has the function that controls the heater temperature, the RIP can control the
heater temperature. (For the setting procedures, refer to the reference manual of the RIP
used.)
• Use this machine under 20 to 35°C. The temperature may not reach the set value due to the
environmental temperature condition.

Confirming the heater temperature

1
When <LOCAL> is displayed, press the
key.
HEATER
• The current heater temperature is displayed.
2
Check the current heater temperature.
• The current heater temperature is displayed.
3
Press the
• <LOCAL> is displayed.
key to finish.
END
Preparing Heaters
< L OCA L . 1 >
PRE PR T
4 0 ° C 5 0 ° C
2-33
2