MIMAKI UJV-160 Operation Manual page 49

4
Turn the clamp lever to the back.
• Set the media straight.
5
Select "LEAF" with the
6
Media detection starts.
( 1 ) The media width is detected.
( 2 ) The media is fed and the rear end of the media is detected.
( 3 ) When the detection is completed, <LOCAL> is displayed.
• When a space between the media and the head is wide, a
screen shown on the right is displayed and the media cannot
be detected.
In this case, lower the head height. (
• Set media on the left by 55mm or more from the side plate on the right.
• If a media is on the right more than fixed position, a warning
is displayed. Set the media again.
7
Adjust the head height.
• Adjust the head height according to the media thickness. (
key.
P.2-26)
Media
Media retainer
Setting media
MED I A S E L EC T
RO L L < > L EA F
DE T EC T I NG WI D T H
P L E A SE WA I T
ERROR 5 0
WI D T H
MED I A POS I T I ON
Side plate (right)
P.2-26)
2-19
2