MIMAKI UJV-160 Operation Manual page 51

• To set media flat, move the screws on both sides of the support table (8 screws on each side)
to adjust the tilt or the parallelism of the support table.
2
Adjust the position of the rigid media
retainer rack right/ left (the front of this
machine)
( 1 ) Put a media used on the front support table
(the front of this machine) along the right rigid
media retainer rack.
( 2 ) Unscrew the left rigid media retainer rack, and
mount it at the nearest position of the left of the
media.
• The right/ left rigid media retainer rack can be unscrewed and positioned.
If setting media in some other way, position the rigid media retainer racks so that the media is
set in the center of the rigid media retainer racks on both sides of the table.
3
After setting the support table, lock the
casters of the support table.
Setting media
Rigid media retainer rack
2-21
2