Cleaning The Drive Rollers And Transport Area - Scantron iNSIGHT 30 Operator's Manual

Table of Contents

Cleaning the Drive Rollers and Transport Area

Emulsiclean

Wipe

DO NOT use the

Emulsiclean

wipe in this

area

Operator's Guide

Remove the wrapping from a transport cleaning sheet

(part number 896 2201).

Adjust the paper feeder guides to fit the cleaning

sheet.

Feed the transport cleaning sheet, adhesive side up

and in portrait orientation, through the scanner by

placing it in the input tray and scanning. Repeat this

procedure until all residue is removed from the top

drive rollers.

Using the same cleaning sheet, repeat Step 3, but this

time with the transport cleaning sheet adhesive side

down and in landscape orientation (so that you are

using fresh adhesive). Repeat this procedure until all

residue is removed from the bottom drive rollers.

When a cleaning sheet gets very dirty, discard it

NOTE:

and use a new one.

If the transport cleaning sheet does not clean the

rollers and the transport area sufficiently, use an

emulsiclean wipe (part number 137 4966). Manually

rotate and wipe the white and red drive rollers with the

emulsiclean wipe.

CAUTION:

DO NOT USE THE EMULSICLEAN

WIPE ON THE FOAM TIRES. The tires will

absorb the liquid and will have to dry out before

you can resume scanning.

Chapter 4: Maintenance