Connecting The Power Cord To The Scanner - Scantron iNSIGHT 30 Operator's Manual

AU10S3
Australia
Note: Places listed are a general guideline only.
Operator's Guide
The following setup steps are included as part of the
NOTE:
software installation program. They are included here
with additional information.

Connecting the Power Cord to the Scanner

Use only the power supply that was provided with your
Scantron iNSIGHT 30 Scanner. Do not substitute
another power supply model or another manufacturer's
power supply.
After the drivers have been installed, use the following
procedure to connect the power supply and power cord to
the scanner. Make sure that the power outlet is located
within 5' (1.52 meters) of the scanner and is easily
accessible.
1.
Select the appropriate AC power cord for your region
from the supply of power cords packed with your
scanner.
V3203C
China
PS204
North America
Installing the iNSIGHT 30 Drivers and Scanner Utilities Software
M2511
Europe
MP5004
TW15CS3
Taiwan
United Kingdom, Ireland,
Hong Kong, Malaysia,
Singapore
Chapter 3: Installation
M755
Japan
45