Scantron iNSIGHT 30 Operator's Manual page 104

Operator's Guide
5.
Gently lower the separator module release lever back
into place and set the separator module aside.
6.
Remove each tire by sliding it off the core.
7.
Install each new tire by gently stretching it over the
core.
Do not overstretch the tires as they may tear.
CAUTION:
Also, make sure that each tire is centered on the
core and lies flat.
8.
Reinstall the core (the direction does not matter).
9.
Reinstall the separator module by aligning the shaft
ends and snapping it into position.
10.
Lower the scanner cover and press it down firmly
until it latches into place.
Chapter 4: Maintenance
Replacing the Separator Module and Separator Module Tires
Shaft Ends
91