Scantron iNSIGHT 30 Operator's Manual page 66

Operator's Guide
3.
The Connect your scanner... dialog box appears.
Click Calibrate.
4.
The Step 1 of 2... dialog box appears. Place a stack of
Normalization & Calibration Sheets (part number 202
502 043) into the input tray, printed side down, so that
the words "Normalization & Calibration Sheet" enter
the scanner first (as shown in the photo below).
5.
Click OK.
If the lamps have been off, the Lamps warming up...
dialog box appears. Please wait while the lamps warm up.
6.
When the lamps have warmed up, the Calibrating
front/top camera... dialog box appears and scanning
begins. Please wait while the software and scanner
performs front side calibration.
Chapter 3: Installation
Getting Ready to Scan
53