Scantron iNSIGHT 30 Operator's Manual page 93

Chapter 4: Maintenance
Cleaning the Separator Module
80
3.
Inspect the tires. If the separator module tires show
signs of wear or damage, replace the tires or the
separator module. See "Replacing the Separator
Module and Separator Module Tires" on page 90 for
procedures.
4.
Reinstall the separator module by aligning the shaft
ends and snapping it into position.
5.
Press firmly until the separator module clicks into
place.
6.
Lower the scanner cover and press it down firmly
until it latches into place.
Shaft Ends
Scantron iNSIGHT 30 Scanner