Installing The Insight 30 Drivers And Scanner Utilities Software - Scantron iNSIGHT 30 Operator's Manual

Chapter 3: Installation

Installing the iNSIGHT 30 Drivers and Scanner Utilities Software

Installing the iNSIGHT 30 Drivers and Scanner Utilities
Software
42
Install the software
CAUTION:
scanner to your PC.
The iNSIGHT 30 Drivers and Scanner Utilities
installation program installs the following software:
• TWAIN Driver: The software utility program that
controls the scanner.
• Scan Validation Tool: A software program that
enables you to test the scanner's document imaging
capabilities.
• Click&Scan: A software program that allows you to
perform document imaging tasks with just a few clicks
of your mouse.
• Calibration Utility: A software program that is used
during setup to calibrate the scanner for data collec-
tion. After setup, this program should not be used
unless the scanner has been moved to a different com-
puter, the scanner has been exchanged for a new one,
or you are directed to do so my Scantron Customer
Support.
• Scanner Exerciser: A software utility program that
Customer Support uses to test the data collection
capabilities of the scanner.
NOTE: Some of the software above requires the Micro-
soft .Net Framework to function. The installation
routine will also install the .Net Framework if it is
not already installed.
Use the following procedure to install the software and
connect the scanner.
1.
Insert the iNSIGHT 30 Drivers and Scanner Utilities
CD into the CD-ROM drive.
2.
Browse to your CD-ROM drive, and then double-click
Setup.exe.
before
connecting the
Scantron iNSIGHT 30 Scanner