Getting Ready To Scan; Step 1: Calibrate Your Insight 30 - Scantron iNSIGHT 30 Operator's Manual

Getting Ready to Scan

Operator's Guide
Once the hardware is connected and the drivers are
installed, perform the following to be ready to scan
documents:
• Step 1: Calibrate Your iNSIGHT 30 (page 51)
• Step 2: Running the Document Imaging Test
(page 56)
• Step 3: Installing ScanTools Plus Software (page 59)
• Step 4: Configuring the Scanner (page 59)
• Step 5: Running the Data Collection Test (page 60)

Step 1: Calibrate Your iNSIGHT 30

CAUTION: The iNSIGHT 30 Calibration program
should only be run for the following reasons:
• upon initial installation
• you are directed to by Scantron support
• you move the scanner to a different computer
• your scanner is exchanged for a new one.
Chapter 3: Installation

Getting Ready to Scan

51