The Scan Validation Tool Diagnostics Window
Operator's Guide
This section describes the functionality found in the
Diagnostics Window. In order for all three tabs (shown on
the next page) to be available, you must enter the
diagnostics window from the Scan Validation Tool (SVT).
Use the following procedure to bring up the diagnostics
window:
1.
Select StartProgramsScantronDocument
ImagingScan Validation Tool. The Scan Valida-
tion Tool dialog box appears.
2.
Drive Types: TWAIN and Drivers: Scantron
iNSIGHT 30 are already selected. Click OK to
continue. The Scan Validation Tool appears.
3.
Click the Setup button (shown in the margin). The
main iNSIGHT 30 scanner (TWAIN Driver) window
appears.
4.
Click Settings (shown in the margin). The settings
window appears.
5.
If you see the Device button (shown in the margin),
click it. The device window appears.
If you do not see the Device button, then you are
already in the device window.
6.
Click Diagnostics. The diagnostics window shown
below appears.
From this window you can access the diagnostic func-
tions of the scanner. The diagnostics window includes
the following tabs: General, Debug and Logs. See the
rest of this section for details.
Chapter 6: Troubleshooting
The Scan Validation Tool Diagnostics Window
127