Scantron iNSIGHT 30 Operator's Manual page 95

Chapter 4: Maintenance
Cleaning the Feed Module
82
3.
Manually rotate and wipe the feed module tires with a
slightly damp staticide wipe (part number 830 9783).
If the wipe contains too much liquid, squeeze it out or
let it dry out for a couple minutes before using.
Slightly Damp Staticide Wipe
4.
Inspect the feed module. If the feed module tires
show signs of wear or damage, replace the tires or the
feed module. See "Replacing the Feed Module and
Feed Module Tires" on page 87 for procedures.
5.
Remove any dust or debris from the tray area under
the feed module and the front roller cover.
6.
Insert the feed module by aligning the pins and
pushing it toward the right to fit it into position.
7.
Reinstall the front drive roller cover making sure that
it is securely latched.
8.
Lower the scanner cover and press it down firmly
until it latches into place.
Scantron iNSIGHT 30 Scanner